That is an interesting bit of trivia!
I have an aluminum boot lid, but would like to know where the cut ends on both
the alum & steel lids.
Gary Hodson
Where the cut ends up depends if it is a steel or aluminium boot lid.
-----Original Message-----
From: josef-eckert <josef-eckert at t-online.de>
To: Michael MacLean <rrengineer.mike at att.net>; Healeys, Forum <Healeys at
autox.team.net>
Sent: Tue, Jan 17, 2017 12:56 pm
Subject: Re: [Healeys] Trunk Seal
Mike it is the correct seal for a 100 and the sharp edge goes to the outside.
Where the cut ends up depends if it is a steel or aluminium boot lid.
Josef Eckert
K?nigswinter/Germany
-----Original-Nachricht-----
Betreff: [Healeys] Trunk Seal
Datum: 2017-01-17T03:22:22+0100
Von: "Michael MacLean" <rrengineer.mike at att.net>
An: "Healeys Help" <healeys at autox.team.net>
Is this the correct cross section for the 100 trunk seal. Of course it is a
Moss item I bought a few years ago. Just getting around to addressing the
trunk area. Which side goes towards the inside of the trunk? All the way
around in one piece? Where is the cut ends end up?
Mike MacLean
?
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170117/e9de2eb3/attachment.html>
|