I use .002" for all TR6 cast pistons...
Steve Yott
-----Original Message-----
From: Fot [mailto:fot-bounces@autox.team.net] On Behalf Of Greg & Alison
Blake
Sent: Wednesday, August 06, 2014 6:12 PM
To: 'FoT Triumph'
Subject: [Fot] TR6 cast piston clearance
I am building a motor for an endurance race TR6 (Chump, WRL.) I'd like to
know what the group recommends for piston to bore clearance for a County
brand +0.040" piston. These are cast pistons.
Thanks in advance.
Greg
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|