Oh, and Greg happened to have a set of 3/16" thick shoes in stock that went
right on.
Sent from my iPad
On May 29, 2013, at 6:31 PM, "Bill Tobin" <william.tobin31@verizon.net>
wrote:
> Hi Gang, I have a question about rear brake shoes for the rear of my TR6.
> For the third time, I'm replacing the rear shoes with uprated ones.
> For the third time, the new shoes will not accept my finned aluminum drums.
> With the adjusters backed completely off, the drums won't go on. Before
they
> wouldn't accept the standard drums until I had them turned quite a bit (not
a
> problem, the drums seem to be very thick).
> I talked too Porterfield and KFP over the last couple years, they both said
> the shoes were arced to specs. I'm now using Ted S's shoes; same problem.
> I'd like to run the finned drums but will not have them cut that much
> undersized.
> Any insight? Ted?
> Thanks, Bill
> PS, if you go to a brake shop and ask about arc grinding shoes, they look
at
> you funny!
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/dlhogye@comcast.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|