On 4/12/2013 7:07 PM, Enquiries Road & Track wrote:
> thanks for all the replies guys. my car is a TR5 (same as 250) and when i
> wrote the message I said TR5 or TR6, forgetting about the different width
> of TR6 wings/fenders (whatever you call them)
>
> So, back to basics,,,, who can comment on TR4 or 250 wheel tyre sizes
>
> Terry
> _______________________________________________
>
Terry, I just now dropped a plumb line from the outer lip of the fender,
then measured from the hub surface: it measures 3 1/2 inches. With that
dimension you can calculate, for a given wheel offset and tire (tyre)
width/aspect ratio, where the sidewall will be.
Now, if only I'd done this a month ago, I wouldn't be in my current
predicament. :-(
jim
--
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|