II just fit a set of these last year luckily managed to get a set or
originals from a friends 240z.
I had to open up the center pilot hole on a lathe to match the TR6 hub
with a little clearance.
The inner part of the drum labyrinth needs to be cut down to clear the
backing plate.
I did that on a jury rigged brake lathe but I'm sure it can be done on
most lathes.
I've seen new 240Z finned aluminum drums in Brembo Boxes so I'm sure
they are still available.
Glenn Franco
Just got my grille badge yesterday Very Nicely Done!
> I believe that you have to do alittle grinding to make them fit right but
> they work good, in one of Jack Drews articles he gives you all the needed
> demensions, I have done this and it is cheaper depending on what your time
> is worth.
>
> On Tue, Dec 21, 2010 at 4:33 PM, Tony and Annie Garmey<
> horizonracing@msn.com> wrote:
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|