Group
Thanks for all the advice on managing the thrust washer issue on this
TR6 engine.
Following Geoff Byrne's advice, I fired up my trusty Atlas lathe and
went to work.
I machined a counterbore in the scored cap to accept a new bronze full
circle thrust washer also machined on the lathe.
The attachment to the cap will me made with brass countersunk machine
screws.
Plan is to see if the rear thrust washers conform to the scored, but
somewhat smooth, crank thrust surface.
The owner wants to drive it this summer.
Also monitor end play and pull the engine in the fall if it becomes
excessive and grind the crank.
It's not all complete but making good progress.
Thanks again
Glenn
Glenn Franco wrote:
> Group
> I've been working on a friends 74 TR6 and we discovered lots of crank
> end play.
> I checked the end play because he was complaining of hard shifts or
> grinding while putting the trans in reverse.
> I removed the pan and found the thrust washers in the oil pan..
> I've run into large end play issues with the TR6's but this is the
> first I've seen in the pan.
>
> Understanding that this is a common malady with the TR6, I ordered a
> few sets of oversize thrust washers.
> Don't think there is enough material in a .025" oversize bearing to
> fix the problem.
>
> I pulled the bearing cap and didn't see major wear in the thrust face
> of the crank. I will need to do a closer inspection of the block
>
> Anyone out there seen a reasonable/simple fix for this problem?
>
> Thanks in advance
> Glenn Franco
> TR6's, 250 and Spit racer
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/fot/gaf3@charter.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|