I had one of my oil gallery bolt holes in my engine block tapped to
accept a 3/8 NPT to -10AN fitting. This was done in the machine shop
before the block was cleaned. My machinist said it could be done with
an assembled motor with thick white grease in the hole to trap metal
bits from the tapping but I didn't feel comfortable doing it. I sent
a picture to Mike of the fitting in the block. If anyone else wants a
picture please email me.
~Steve
On May 5, 2010, at 1:32 PM, Mike Mehl wrote:
If I recall there was a thread a few months ago where one of you
explained how
you adapted the oil galley plugs to manifold your Acusump into the
galley. In
fact I recall some one sent me photos. I have deleted that email. It
would
be great if you could resend.
Thanks!!!!
Mike Mehl
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/colordog.1@earthlink.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|