Got the head back - dressed it up and assembled. Noticed that with .090
shaved off, the headgasket (stock 86mm) protrudes into the chamber under
the exhaust valve. Jack notes predicts this but not quite sure the best
way to deal with it. I worked up the edge of the copper and can probably
shave it back and roll it over again but it would get pretty close to
the water relief. Can I run it protruding Jack notes says it won't last
but I'm only .090 not racing all the time so...
How do you guys deal with this?
M
_______________________________________________
fot@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|