Ditto that!
I am in the process of fitting a set in an engine right now, VERY impressed
with these so far, I expect that they will work well.
Thanks to Greg!
Glen
-----Original Message-----
From: MORDY DUNST <gasket.works@verizon.net>
To: 'Friends of Triumph' <fot@autox.team.net>
Sent: Fri, Feb 5, 2010 10:50 am
Subject: [Fot] Tappets...
FYI
NO Financial interest...
I just purchased a set of the finest looking Tappets for a TR4 I have ever
seen. ( Fyi... a few years back I had about ten sets made out of A2 Tool
steel) . These are so superior in quality. You could shave of the
brilliance of the mirror finish. They are harder than RC 60.
In a figure of speech called a "litote" they are not " not inexpensive" but,
they look like a deal well worth the effort.
Contact Greg Solo's Engine room.831.429.1800 in Santac Cruz.
.
Mordy
M.N.Dunst
Gasket Works USA, LLC
www.Headgasket.com
626.358.1616 ph
626.628.3777 fx
Triple R Munitions, Inc.
Class 6 Certified F.F.L.
626.201.9471
GMT -8 Pacific
Suggested annual donation $12.96
You are subscribed as fubog1@aol.com
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|