Oops, sorry about the typos. The heater pipe hasn't screwed anything as far as
I know!!!
I need a plug to block off the heater pipe hole atop the head. :)
-----Original Message-----
>From: steve <colordog.1@earthlink.net>
>Sent: Dec 22, 2009 11:40 AM
>To: FOT <fot@autox.team.net>
>Subject: [Fot] Engine Plug Sizes, oil press pickup
>
>FOT,
>
>What sizes are the following plugs for the TR3/4 engine:
>
>1, top of Cyl Head where heater pipe screwed it.
>
>2, Manifold side of engine block to drain H2o.
>
>
>Also, on your cars, where do you pick up the oil pressure for the pressure
>gauge?
>
>
>
>~Steve
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as colordog.1@earthlink.net
>
>http://www.fot-racing.com
>
>
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
>
>Brought to you by Team.Net consulting - Unix software specialist.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|