I know that Jack has done this in the past, but don't know the
details on the flywheel that was installed. He also has replaced the
rear seal this way, but I have no idea how he pulled that off.
- Tony Drews
At 09:10 PM 11/10/2008, J.C. Hassall wrote:
>I need to change the main bearings in my TR4. The engine is in the
>car with the gearbox attached. Is it possible to pull the rear main
>cap? I'm specifically concerned about the seal - I have the new
>split-type seal. I took lots of pix of the engine as I assembled it
>*except* the split seal and associated bits.
>
>TIA
>
>jim
>
>--
>J.C. Hassall
>Blacksburg VA
>'63 TR4 in autox preparation
>96% finished, 90% to go _______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>http://www.fot-racing.com
>
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|