I'm running Brad Penn Racing 20w50 "Partial Synthetic" oil.
Hey all, please let's not get into the ZDDP discussion again :(
~Steve
On Oct 31, 2008, at 10:31 AM, Norlin Engineering wrote:
> Steve
>
> While I can't respond with a specific recommendation for the TR, I
> can speak
> from experience that it depends upon the type of oil you are using.
> Years
> ago I had a well worn Formula Ford. I raced it with Valvoline 20-50
> conventional oil with no problems. I got talked into trying some
> 20-50
> Amsoil synthetic to reduce friction, etc. The blow by was so great
> that I
> blew out all the oil from the dry sump tank in just a few laps.
>
> Jim Norlin
>
> -----Original Message-----
> From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net]
> On
> Behalf Of Steven Belfer
> Sent: Friday, October 31, 2008 9:59 AM
> To: FOT
> Subject: [Fot] TR3 / 4 Piston to Wall clearance
>
>
> I have a well used race motor in the machine shop. It's got Hepolite
> Powermax cast pistons and 87mm sleves that have seen many races. The
> liners
> may need a bit more than a light honing to freshen them
> up. What would you accept as the max allowable P to W clearance? I
> don't
> really want to buy new liners if I don't have to.
>
>
>
> ~Steve
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|