FOT,
The steel flywheels are arriving at their intended destinations and I have
been asked what I would recommend for fasteners.
What doth the list sayeth?
This is a worthy question. I use a particular fastener (4) with Loctite and
no washers or locking tabs.
It would be good to see a consensus on keeping this rotating mass in place. I
likely have no more than 125HP and seldom go beyond 6,000 RPM. Thus, the
answer maybe different for others.
Joe A </HTML>
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|