GM has a typical check valve for $10-15 if you make your own.
This system will: "...provide better piston ring seal, less intake charge
contamination, and reduced oil leaks caused by high crankcase pressure."
This is from a circle track catalog. A little marketing hype built in here, I
sense.
Moroso, Mr. Gasket, and Renegade provide these kits to the circle track guys.
There are pieces uneeded for Triumphs and no hi temp poly tubing, which may
be the most expensive item.
I have no understanding of why they are not permitted in the SCCA GCRs.
Likely for good reason in certain applications...V-8s?
But for TR3/TR4 engines, it seems like an appropriate modification.
I was putting a lot of oil into the frame rails and then would dump it ON the
exhaust pipe at Turn Five at Road America. Not a very pretty cloud of oil
smoke and of some concern to the corner workers.
After going home, I would let the TR4 drip for a couple of weeks, then wipe
it down.
This system changed all of that.
Joe A
> Bill,
>
> To avoid ANY back pressures you should fit a one way / check valve at the
> exhaust venture. These type of check valves are available on some emission
> vehicles. Problem solved. That what I have on my TR4.
>
> Peter V
> TR-4
>
</HTML>
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|