Dennis-
No matter what you do, the stock outer axle is the big problem...it will break!
I run a basically unbreakable chevy setup.? A corvair outer axle drilled for a
TR lug pattern, with a Corvair hub assembly. Cut off all the protrusions on the
Corvair hub assembly so it will fit into the TR trailing arm, and weld on a
flange to mount onto the TR trailing arm.? Use a GM ujoint and cut down one
side so as to mount to the Corvair stub axle on one side and the TR sliding
axle on the other. Actually much easier than it sounds.
Drivin the?Chevumph...Triolet?
????????? Nick in NorCal
-----Original Message-----
From: Dennis DeLap <yellow-green@sbcglobal.net>
To: FOT <fot@autox.team.net>
Sent: Thu, 29 Nov 2007 5:51 pm
Subject: [Fot] TR6 rear hubs
Amici - I have a question for those who are racing a TR4A - TR6. What have you
done to make the rear axle/hubs safe? Upgrades, modifications, etc.
Thanks
Dennis DeLap
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
________________________________________________________________________
More new features than ever. Check out the new AOL Mail ! -
http://o.aolcdn.com/cdn.webmail.aol.com/mailtour/aol/en-us/text.htm?ncid=aolcmp00050000000003
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|