There's a lot to be said for using all the same size cylinders if you
are going to have a bias bar. For one thing, you only need one spare
rebuild kit for all three MC.
On Oct 23, 2007, at 1:25 AM, Joe Boruch wrote:
> Dave, I am on the road for the week, so can't look to see what I
> have where,
> but I have two 0.70 masters and one 0.75 master. I think the 0.75
> is front
> and a 0.7 for clutch and the other for rear. I, however have
> Jaguar 3 piston
> front calipers and Wilwood rear calipers, so my car may not be a good
> comparison. I went with the Wilwood pedal assembly with Tilton master
> cylinders. Initially this was because the Tilton pedals were on
> back order,
> but after looking at them closer I liked the Wilwood ones better
> for how I was
> going to mount them. They also have non-slip pedals. Download the
> drawings
> and compare them. Joe(B)
>
> -- SpiwakD@aol.com wrote:
> Am considering a Tilton pedal setup with master and slave cylinders
> for TR3.
> Who knows what size piston to order?
>
> Dave
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|