Sure. I've taken quite a few apart and have had to use a case
spreader tool only once or twice. The odds are that you can remove
the diff without it. You take off the rear cover and turn the diff
carrier so that the open sides of the casting are on the top and
bottom, as viewed from the rear of the car. Then you take two long
screw drivers or similar pry bars, stick the ends into the cavities
of the carrier, and pry it right straight out. You can usually move
it far enough that you can then get your fingers in there and lift it
the rest of the way out.
At 10:59 PM 7/8/2007, you wrote:
>I'm installing ( or trying to install ) a Phantom Grip LSD device in my
>IRS diff. Does anyone know the proceedure for disassembling
>the differantial with conventional tools ?
>Jim Gray
>Aurora, Co.
>_______________________________________________
>http://www.team.net/donate.html
>
>vinttr4@geneseo.net
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
uncle jack
------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|