Correct me if I'm wrong, but isn't 3/8" what is needed to install wire
wheel hubs to a standard hub, if you don't want to replace or cut the
standard length studs.
3/8" spacers would be perfect for that... and a lot of people might be
able to use those.
2 x 3/8" would be what Bill wants
4 x 3/8" would be what Joe wants.
Hmmm......
--Justin
SHANE Ingate wrote:
>Uncle Jack,
>
>I suspect that there are many FOTers (myself included) who
>need a set (of 4) well-made spacers for TR4 and TR6 hubs -
>I expect that IRS and non-IRS are the same.
>
>The problem becomes thickness. Joe wants 1.5", Bill wants
>0.75" and I am sure there are other sizes desired.
>
>It may be worthwhile taking a poll to see if there is sufficient interest
>for a manufacturing run. Thinner spacers can be cascaded to make
>a thicker spacer, e.g., two 0.75" spacers make a single 1.5" offset.
>
>0.75" works for me.
>
>Shane Ingate, playing with 2" spacers and 0-offset wheels, in Maryland
>
>Bill Babcock wrote:
>
>
>>Oooh. Cool idea. I'd love some 3/4" wheel spacers that fit the hubs.
>>
>>
>
>_________________________________________________________________
>Get in the mood for Valentine's Day. View photos, recipes and more on your
>Live.com page.
>http://www.live.com/?addTemplate=ValentinesDay&ocid=T001MSN30A0701
>_______________________________________________
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|