| To: | "Jack W. Drews" <vinttr4@geneseo.net>, fot@autox.team.net |
|---|---|
| Subject: | Re: [Fot] bore sizes |
| From: | Gasket Works USA <gasket.works@gte.net> |
| Date: | Fri, 22 Dec 2006 17:35:33 -0600 (CST) |
I use 89 mm liners but, 87mm pistons. This reduces side friction load. It reduces side thrust loads and HP loss. m M.N.Dunst Gasket Works USA, LLC gmt-8 Pacific time 626.358.1616 voice 626.628.3777 fax _______________________________________________ Fot mailing list Fot@autox.team.net http://autox.team.net/mailman/listinfo/fot |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Fot] bore sizes, marshall |
|---|---|
| Next by Date: | Re: [Fot] bore sizes, Dennis DeLap |
| Previous by Thread: | Re: [Fot] bore sizes, marshall |
| Next by Thread: | Re: [Fot] bore sizes, Dennis DeLap |
| Indexes: | [Date] [Thread] [Top] [All Lists] |