In a message dated 12/16/2006 8:55:13 AM Eastern Standard Time,
triumph_marx@freenet.de writes:
the liners stand
above
> the block around.002/.005".
I can't say for sure that it's the cause of your problem but that's too much
variation in liner heights. I use 2-3 for steel & 4-5 for composition
gaskets, & make sure to retorque.
Also make sure that you have clearance between the underside of the water
neck on the front of the head & water pump housing.
Hope this helps,
Glen
Glen
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|