Slither or slather, it's a sure bet that stuff will be EVERYWHERE. I swear I
can see it in a magazine advert and wind up with it on me somewhere! That
stuff is diabolical (but it sure works).
Chuck, who's going to Pahrump??
I've never tried that but wondered if it would work. Do you use a thin
or thick coating? (Slather or slither)
Bob Kramer
Sales Manager
16415 North IH35
RDO Equipment Co.
Pflugerville, TX 78660
800-775-3838
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On
Behalf Of chasgee@aol.com
Sent: Monday, May 15, 2006 1:55 PM
To: Gt6steve@aol.com; fot@autox.team.net
Subject: Re: [FOT] Heavy duty manifold gaskets
Use the aluminum paste anti-sieze. Works really well for this sort of
thing.
Chuck
-----Original Message-----
From: Gt6steve@aol.com
To: fot@autox.team.net
Sent: Mon, 15 May 2006 12:05:20 EDT
Subject: [FOT] Heavy duty manifold gaskets
Good Mornin' Amici,
Maybe a little brainstorming on a Monday morning?
I found the heavy duty six cylinder manifold gaskets I wanted at APT.
Apparently they're thre ones Moss was selling but discontinued. They go
on
great,
seal well but don't come off for reuse. The white cardboard burns,
get's
crispy and sticks to the surfaces. I was thinking of covering both
gasket faces
with a layer of heavy duty aluminum foil from the kitchen to resolve
that issue.
Later I wondered if Cop-a Slip antisieze in the spray can was an
option. Or
silver paint.
Anybody have any opinions to share.
Steve
|