In a message dated 3/15/06 12:17:11 PM Pacific Standard Time,
mcandrew@pol.net writes:
<<
I have had a small exhaust leak between the block and header at the forth
cylinder on my TR3. I'm putting on a new gasket. Do you use any type of
sealant or dressing on the gasket?>>
I have been putting a thick layer of ball joint grease on both sides of my
gaskets. When you first fire up the engine, there is a lot of smoke for a
while. It seems to form a carbon seal. I also install two gaskets, or double
gasket it, which seem to help. There may be better ways.
|