Joe, I know there might not be much need for this, but how about a heat
shield for PI? It might be similar to the triple Weber setup.
Charly
TR6 #44
----- Original Message -----
From: <N197TR4@cs.com>
To: <fot@autox.team.net>
Sent: Saturday, October 22, 2005 6:58 AM
Subject: Weber Heat Shields for 40 & 45 DCOE
> FoT,
>
> We now have Heat Shield for SUs and Strombergs in production for TR3
through
> TR6. (TR4A Center Pull and TR6 are pending)
>
> HOWEVER, I have had several requests for Webers, but know very little
about
> them. if it were possible to come up with individual heat shields that
fit
> the common Webers for most applications, it would be worth doing, I think.
>
> Mounting Points seem to be the largest issue? I have a manifold and a pair
of
> 40DCOEs on the shelf, so I at least have a reference.
>
> I have one guy interested in doing a model for his Triple Webers on his
TR6.
> He is an architect, so design likely is not an issue. If you would like to
> participate in this development, please send me your requirements and
contact
> information and I will take a shot at producing.
>
> Dardano, Frymark, Dunst, Wakeman have expressed an interest in the past.
> Anymore out there. I will explore all of the way through cost/price if I
get
> enough interest.
>
> BTW, the alloy front engine mounts for TR3s and TR4s are in the production
> line up. Perhaps two weeks to shipping.
>
> Joe (A)
|