Jack,
Would it be Speedway Engineering?
I use their 1.25's on my TR6 but I usually run slicks that are stickier
than vintage tires.
Mike
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On
Behalf Of Jack W. Drews
Sent: Wednesday, August 10, 2005 5:57 PM
To: Randy Williams; fot@autox.team.net
Subject: Re: Fornt sway bar
I have more or less continually increased the size of my front bar,
with the maximum ending up at 1-1/8". At that point, the car finally
started to understeer too much, so I went back to my 1" bar. I still
have the 1-1/8" bar that I'd part with for half what I paid.
The only place where I could find such a beast was by going the
NASCAR route, with a bar with splined ends, detachable arms, and Heim
connecting joints. If you want this one, you'll have to get a pair
of arms, pillow blocks, and links.
I'll have to go back through my receipts file to find the vendor.
At 03:32 PM 8/10/2005, you wrote:
>I am looking for an 1 1/8 inch sway bar for a Triumph TR3 can anyone
>recommend a source. Thanks, Randy
|