Please respond to the whole list on this one. I had the same thing
happen the other day and figured it was too lean a mixture at low revs.
Now I'm curious.
Thx, Don TR4A
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On
Behalf Of riverside
Sent: Monday, April 11, 2005 1:19 PM
To: fot
Subject: red hot headers
fired up a fresh engine with tube headers last week and the
headers went to glowing red hot and 1000 deg F in about
2 minutes at 1500 rpm. shut it down. unfortunately, did not
have an air/fuel meter. last time i did a tractor motor with
cast iron ex manifold, we only got to about 650 and held there.
couple days later ran across an article saying that such a condition
is caused not by a lean mixture, but more likely cam timing or
rich mixture allowing the fire to still be going hard in the header,
don't recall ever getting a TR header that hot.
any comments from the engine guys in our group about the cause of
the glowing headers and hazards to continuous operation.
art de armond
|