Don Marshall asked:
>I guess it's time to move the oil cooler from inside the radiator shroud
>down to the valance where everyone else seems to have theirs. Before I
>start cutting, is there a source for premade grills or do we all just
>use hardware store screening? Also, once the hole is cut, is there any
>tried and true mounting technique or do we just figure it out from
>scratch? I suspect someone on FOT has done lots of these before.
If you are going to cut sheet metal, you may as well braze some bolts
(sans head, natch) to the backside of the sheet metal around the
perimeter of the hole, place the grill over the bolts and snug it down with
a washer and nut. Like everyone else, I use the 6 squares/inch s/s
screen from Pegasus.
Shane Ingate in Maryland
"Anyone can rebuild a car. It takes a real man to cut one up."
_________________________________________________________________
Planning a family vacation? Check out the MSN Family Travel guide!
http://dollar.msn.com
|