> I guess I asked this question when everyone was off at a race. I'll
> try again.
One of the problems with everyone answering off-list ... never know if
someone else answered or not.
> For a TR3-4 distributor
>
> I'm looking for the diameter of the lock pin hole in the lower
> distributor shaft. The one that holds the drive gear in place.
The one that I picked up from the parts bin seems to be about .192" ... a
#11 drill shank will go in slightly but not all the way through.
> Also the distance between the bottom of the distributor shaft and
> centre point of the hole.
I make it to be about .809" ... I measured .713" from the end of the shaft
to the side of the #11 drill shank.
Note that the hole in the dog is slightly smaller, about .185"; and that
both holes are off-center so the dog can only go one way on the shaft.
Randall
|