I can't find a spec. It's a sliding fit on all the blocks I've done. What
I'd call a plastic mallet fit--too tight for a rubber mallet, but moves if
you bang on it with hard plastic.
-----Original Message-----
From: Peter Vucinic [mailto:vucinic@b140.aone.net.au]
Sent: Tuesday, February 25, 2003 6:16 PM
To: FOT
Subject: TR4 Sleeve to Block Fit
Does anyone have the relevant dimensions / limits of fit, for the TR4
cylinder liner into the cylinder block? I am assuming that it is either
slight clearance or size-for-size?
Any help greatly appreciated.
Kind Regards
Peter Vucinic
WORKS-4
TR-4
|