I know there are no stupid questions, but none-
the-less...I'm rebuilding two rear axles for my
Italia and I've run into a problem that I hope
someone can help me with.
Removing the diff and removing the bearings I've
destroyed all the shims and several of the
bearings. How can I set the back-lash, end-float,
etc. with out having to replace everything each
time I dismantle it? If I'm right, I need to
assemble it, measure it, dismantle it (and
destroy everything I just put in) and start over.
Am I missing something obvious? I can see how
some modifications would make this easier, but
I'm hoping for some tried and true solutions.
Thanks in advance for any help.
Michael W. Engard <mikee@ragtops.com>
Ragtops & Roadsters, Inc. www.ragtops.com
British Automobiles, repairs & restorations
215-257-1202 South-eastern Pennsylvania
|