I know I have asked this question before, but I am still seeking the right
studs for my Spit racer. I have installed TR6 studs per
mark B's recommendation, but they won't stay in the holes of the rear hubs. If
I hold tension on the wheelwhile I screw on the nuts, I
can get them on, but the splines are neither long enough nor large enough in
diameter to stay in the holes.
So I am back to looking for a source of the following studs:
Overall length = 1-1/4 to 1-3/8"
Thread size = 7/16x20
Shank length = 1/4"
Spline length = 1/4"
Spline diameter = .51" (the TR6 ones are .50)
Any suggestions would be most helpful.
Joe (C)
|