In a message dated 6/28/00 5:32:42 AM Pacific Daylight Time,
jaboruch@netzero.net writes:
<< Many machinists tend to get in a rush
and just take 5/1000 off the surfaces and then hone it. That way they
know that they only have to do the honing once, but in this case it
will push the crank up into the block considerably. Joe (B) >>
Thanks a lot for the additional information, Joe. There are a lot of
different angles associated with this operation. That is probably the reason
why several FOTers have advised me to find another block if I believe align
boring is necessary.
|