In a message dated 6/20/00 7:47:13 AM Pacific Daylight Time,
BillDentin@aol.com writes:
<< At Hardy Prentice's suggestion, we have made floating baffles that look
like large washers made out of sheet Teflon that is 1/8 inch thick. >>
<>
I assume that the washer OD cannot be much larger than the axial tube oil
seal ID in order to insert the half shaft. Maybe it is possible to hang a
new oil seal on the half shaft inside the Teflon washer, and pound the seal
into the tube with the half shaft partially engaged -- probably difficult or
impossible.
|