30 ton hydraulic press did the trick very nicely last night. Though the
neighbors of the garage may have reported small arms fire...
I'm a bit concerned over evidence of galling on the axles/ flange mating
surfaces however.
Thoughts/opinions?
> -----Original Message-----
> From: Robert Bownes
> Sent: Friday, July 23, 1999 1:28 PM
> To: fot@autox.team.net
> Subject: TR6 Diff flange question
>
>
>
> Ok those of Great Wisdom....
>
> What is the trick to getting the axle flanges off the
> stub axles in the diff? I wanted to replace the oil seals as
> part of this re-build, but can't get the flanges off the
> axles...Big Honkin Press? I've tried hammer, bigger hammer,
> Blue Hammer, three armed puller, puller + hammer, all the
> usual tricks.
>
> iii
>
|