has anybody tried to seal an oil pan using the gas tank sealer known as
"POR"? don't know if it would stand the heat but should be worth a call to
the manufacturer's rep? no?
-----Original Message-----
From: Gt6steve@AOL.COM <Gt6steve@AOL.COM>
To: fot@autox.team.net <fot@autox.team.net>
Date: Friday, July 23, 1999 6:04 PM
Subject: Fwd: Deepened oil pan
>
>--part1_bd1ddedf.24ca6a7a_boundary
>
>
>
>--part1_bd1ddedf.24ca6a7a_boundary
>Content-Disposition: inline
>
>Return-path: Gt6steve@aol.com
>From: Gt6steve@aol.com
>Full-name: Gt6steve
>Message-ID: <bd1ddedf.24ca68a7@aol.com>
>Date: Fri, 23 Jul 1999 20:53:59 EDT
>Subject: Deepened oil pan
>To: FOT@autox@team.net
>MIME-Version: 1.0
>X-Mailer: AOL 4.0 for Windows 95 sub 10
>
>Well, my friends,
>I am still pursuing the deepened oil pan fiasco. I've learned in
retrospect
>to use two pans to make one deepened to eliminate one complete joint with
its
>associated leak points. I've learned that my welder has the patience of a
>saint as I return it time and again for pinholes. I've learned that
brazing
>in the baffle causes fresh pinhole leaks that cannot be fixed by brazing
(by
>me). At this point I am sending it to the powder coat guy to see if this
>process can close these small leaks. Previous requests for information
>suggested this was an unknown path so we will all learn together. Let's
keep
>our fingers crossed...
>Steve of the Stock Pan
>
>--part1_bd1ddedf.24ca6a7a_boundary--
>
|