Bob Lang wrote:
>
> Hi All,
>
> I'm performing a sanity check:
>
> TR engine block - align boring for cam bearings...
>
> I got a price of $375 for the job.
>
> It sounds high... can anybody provide numbers that support this price???
>
> Oh, and I'm looking for someone to shot-peen some TR6 rods. Any pointers?
>
> C ya,
> rml
>
>-------------------------------------------------------------------------------
> Bob Lang Room N42-140Q | This space for rent.
> Consultant MIT Computer Services |
> Voice: (617)253-7438 FAX: (617)258-9535 |
>
>-------------------------------------------------------------------------------
It cost me $220 to have a TR6 block align bored for cam bearings. The
shop is in Waterloo, Iowa, which may have some bearing on cost (pun
intended) and the work was excellent.
--
uncle jack
TR4 Rallye Replica vintage racer
|