To: | fot@autox.team.net |
---|---|
Subject: | OOPS, never mind... was "Header coating and other questions" |
From: | DLM Assoc <DLMAssoc@aol.com> |
Date: | Wed, 29 Apr 1998 10:39:35 EDT |
Sorry about that... a few minutes after I sent the list of header questions I opened my Kastner book which says; "The tail pipe should be made of 2 1/2" OD tubing", so I guess it's safe to assume a 2.5" pipe will fit through the X member. He also recommends using a 10" length of flex pipe between the header and the tail pipe so the engine torque isn't taken up on the tail pipe hangers. So I guess the question is now limited to "should it be coated, and with what?" Thanks... Don |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Header coating and other questions..., Bob Lang |
---|---|
Next by Date: | Re: Header coating and other questions..., Jack W Drews |
Previous by Thread: | Header coating and other questions..., DLM Assoc |
Next by Thread: | Re: Header coating and other questions, Mark Bradakis |
Indexes: | [Date] [Thread] [Top] [All Lists] |