Group,
I finally got the time and help to adjust my trunk, hood, fenders, and doors
to the body so I can finish the body filler portion of my restoration. The
passenger side door and fender fit and spacing is very good. However, the
driver's side fender and door fit is driving me nuts. The gap between the
fender and door is to wide but I can't close the gap any closer with door
adjustment then it is at this point. My question is, is it possible to
loosen all of the fender fasteners and move the fender further back towards
the door to close up the gap? It looks like I will need about 3/16"
movement to get the correct spacing. I have all of the fender fasteners
installed including the four bolts that are just inside the fender to door
area including a rubber spacer between the three inside bolts.
Thanks
Steve
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|