Dan,
All the low-windshield 1600s and 2000s use the same heater core and heater
control valve, all of which have 5/8-inch nipples. Same with the
connections on the manifold and water pump suction. Where is a different
size used?
Gary
----- Original Message -----
From: <hallosb@juno.com>
To: <datsun-roadsters@autox.team.net>
Sent: Wednesday, November 18, 2009 9:15 PM
Subject: Re: [Roadsters] heater valve water flow
>I would use the stock location. Follow the link to a photo.
> http://community.webshots.com/album/575581420BVQedq
>
>
> You'll need two different size heater hoses for the hook-up. I bought
> heater
> hose reducers (adapters) from NAPA and posted the part numbers on the
> 311s.org
> site.
> Dan McHatton
> '66 1600
>
> ----- Original Message -----
> From: "Bob Ballinger" <12061997@comcast.net>
> To: "datsun list datsun" <datsun-roadsters@autox.team.net>
> Sent: Thursday, November 12, 2009 12:34:50 PM GMT -08:00 US/Canada Pacific
> Subject: [Roadsters] water flow
>
> Hi List, I am going to finally try to install this heater converter in my
> 67
> 1600 and was wondering if anyone had used a different location for
> mounting?
>
> Is there a water flow chart out there to help me figure how this is
> suppose
> to hook up?
>
> thanks bob ballinger
>
> ____________________________________________________________
> Diet Help
> Cheap Diet Help Tips. Click here.
> http://thirdpartyoffers.juno.com/TGL2131/c?cp=dAlcFhosufjydyVadt6UHwAAJz3b-7K
> uMPJffYsq3MtsBROGAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAYQAAAAAA=
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as aultgc@att.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|