I second what John said. If you position the 'handle' right you don't even
have to crawl under the dash. I just reach down past the hood knob and grab
the hanger, works great.
Richard
----- Original Message -----
From: "John F Sandhoff" <sandhoff@csus.edu>
To: "Tim" <tputland@charter.net>
Cc: <datsun-roadsters@autox.team.net>
Sent: Tuesday, September 29, 2009 12:06 PM
Subject: Re: [Roadsters] back up hood release cable
> Actually, your mis-aimed reply that made it to the list may turn out
> to be helpful.
>
>> I am going to order the parts necessary to install a back up hood
>> release..
>
> One coat hanger, one pair of pliers, 5 minutes.
>
> Straighten the hanger, then fashion a loop (for a handle) on one end.
> Snake the other end thru the large grommet on the 45 degree angled
> part of the firewall, from the driver's cockpit, where it lines up with
> the hood release mechanism. Bend and hook the end to the pull-tab
> on the release. Make sure it's crimped so it won't pop loose. Done.
>
> In emergency, crawl under the dash and pull the wire horizontally.
>
> -- John
> John F Sandhoff sandhoff@csus.edu Sacramento, CA
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as reblues@gmail.com
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|