I got a pulley off a Chevy 350 from the junk yard. It worked fine except
the center hole was not big enough to fit on the roadster shaft. It was
easy to drill out.
Andy
-----Original Message-----
From: datsun-roadsters-bounces@autox.team.net
[mailto:datsun-roadsters-bounces@autox.team.net] On Behalf Of Howard @
Everything Christmas
Sent: Friday, September 18, 2009 1:58 AM
To: datsun-roadsters@autox.team.net
Subject: [Roadsters] Large Diameter Water Pump Pulley
Hi All,
Does anyone know where I can purchase a Large Diameter Water Pump Pulley.
Preferably not for a Kings Randsom
I need to slow down the water pump to try and get my engine cooler on a
Solex
Equipped U20 engine on my Race Car.
I am already using a 4 core radiator and ducting to direct the air straight
into the radiator. I need to pull the water temp back 20 degrees c or so.
and
this is one step.
I know one is made for the SR20, but is there anything around for the U20 ?
I installed one that I think came from the Z family that was slightly
larger,
but I would like to try and extra step to something like an 8" diameter as
the
engine mainly runs 4000 to 7500 for circuit racing , up to 60 mile events.
Oh, it is a highly developed race only engine professionally built by a race
engine specialist.
Regards,
Howard, Datsun 2000 Solex 3 of them: one race one road(nearly) and one
wreck.
You are subscribed as andycost@embarqmail.com
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|