Steve,
Look under where that fitting on the head -s and I believe you will
find the location of the original sender. That's where mine is.
Peace,
Pat
-------- Original Message --------
Subject: [Roadsters] Coolant Temp. gauge question
From: "Steve Harvey" <stebharvey@ameritech.net>
Date: Mon, September 29, 2008 11:33 am
To: <datsun-roadsters@autox.team.net>
Group,
My 1970 1600 has never had a functioning temp gauge. I purchased an
aftermarket gauge that came with several different brass fitting
that hold
the copper sensor to the head. I've seen other 1600's that have the
temp
sensor installed at the front (left side) of the head. On my car
there is a
fitting installed into the head which is attached to a rubber hose
which is
attached to a 90 degree tube that goes to a fitting at the front of
the
intake manifold. Do I need this current setup? Is it factory? Can I
put a
"T" fitting off of the head so I can install the temp sensor and
re-attach
the hose and tubing that run to the intake manifold? Or, is there
another
location on the head were the sensor could be installed? Sorry for
so many
questions.
Thanks
Steve Harvey
________________________________________
Support Team.Net http://www.team.net/donate.html
You are subscribed as pat@hornesystemstx.com
Datsun-roadsters mailing list
http://www.team.net/archive
http://aut ox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|