Here's a pic of my new tie-rod along with my new front end:
http://rides.webshots.com/photo/2984644800102308741MuJKHz
Alvin GogineniSan Jose, CA67.5 SPL/SR20> From: andycost@embarqmail.com> To:
datsun-roadsters@autox.team.net> Date: Sat, 27 Oct 2007 17:16:47 -0500>
Subject: Re: [Roadsters] Bent center link - what metal to fabricate a
replacement out of?> > The important part is that both ends are the same
height. If one is lower> then you will have some nasty stuff going on with the
handling. If both> ends are the same height then the center link could be
pretzel shaped and> still work fine.> > Andy
_________________________________________________________________
Peek-a-boo FREE Tricks & Treats for You!
http://www.reallivemoms.com?ocid=TXT_TAGHM&loc=us
________________________________________
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|