If you mean why is one longer than the other then I can explain. There are
wires that runs between the two pieces. It's been a while since I've seen
them but I do believe it was the sending unit wires from the gas tank.
As for the body hold down bolts, you'll have to be more specific. There are
different size bolts and they correspond the same from left to right side.
So, whatcha talkin bout Willis?
Subject: Re: frame padding
> just to clarify - i am referring to the pads between the car body and the
> frame.
>
> can anyone explain to me why the pads in the rear are not symmetrical?
> are
> they different for an early 67 1600?
>
> 311s.org shows a 24" and a 6".
>
> and why, if there are body hold down bolts on each side, that they don't
> correspond?
>
> http://www.311s.org/tech/resto/framepads.html
>
> thanks.
|