www.mcmaster.com catalogue page 3046, rectangular speed nuts for unthreaded
shafts.
If I recall, the posts are 1/8", but you'd want to confirm the diameter
before ordering.
for 1/8", part # 90528A124 flat Bag of 100 $6.75
Best way to deal with broken posts is to glue the die-cast emblems on with
clear silicone - thin bead on back, press on, clean up any excess, and use
masking tape to hold while curing. Did this on our Z ten years ago, and
they're still in place.
Mark Sedlack
ZROC
Cuyahoga Falls OH
66 1600 http://www.mildevco.net/chevypowereddatsuns/
77 280Z http://www.mildevco.net/chevypowereddatsuns/
----- Original Message -----
From: "DatsunSPL" <datsunspl@hotmail.com>
To: <datsun-roadsters@autox.team.net>
Sent: Sunday, November 19, 2006 11:21 PM
Subject: Logo fasteners
> Does anyone know if/where the little press-fit doohickies that fit in the
> holes in the fenders to hold the "Datsun" and "1600" logos are available?
> Thanks,
> Paul
|