Well It looks like the problem is solved. Took upper steering column and
wheel in to house and set up on table. Metal ring at bottom of wheel does
not stay in place and appears to drop slightly on one side. It is only
held up where the copper spring arm sits. Looks like the metal ring is
periodically setting down on the actual signal arm's pivot. This
aftermarket wheel does not appear to be perfectly flat on the bottom either.
I siliconed the metal ring to its plastic holder and put some electrical
tape across the signal arm pivot. Don't think that it's necessary but can't
hurt. Thanks to everyone who had good suggestions. Will let everyone know
how it works out tomorrow. Larry.
|