Hi Everyone,
Daryl thanks for asking the question!
I got my 15 " panasports, ball joints, and tie rods all installed. I need to
get these adjusted at the tire shop. What shop in Vacaville does anyone
suggest? Do I tell them:
Camber: 1 degree negative
Caster: 2.5 degrees positive.
toe should be on the order of 1/8" toe-in.
Is this the settings they need to adjust my camber, caster, and toe where it
should be for street driving?
THANKS so much,
Paul Souza
69 2000
Vacaville, CA
RacerY@comcast.net wrote:
Gordon's right-
his numbers are better than the factory,
and toe should be
on the order of 1/8" toe-in.
You'll be happier.
Toby
-------------- Original message ----------------------
From: "Gordon Glasgow"
> I recommend NOT using the factory settings for camber and caster (stock
>toe-in
> is okay).
>
> Camber: 1 degree negative
> Caster: 2.5 degrees positive.
>
> The other specs you list (min turning radius, angle of inclination of swivel
> axle, etc) are determined by the geometry of the suspension components and
>are
> not adjustable. Don't worry about them.
Get on board. You're invited to try the new Yahoo! Mail Beta.
|