I did some research based on the comments about the thread differences
between the 1/8 NPT threads and the 1/8 BSPT threads. Most of what I found
did not apply, but I did find a place in Wisconsin where you can purchase a
small brass adapter to use between your stock roadster fittings and the
switch Mark suggested.
Here is a link to the PDF catalog page:
http://www.memolub.com/ml_acc.pdf
If all fails this might help.
Tom
69 2000 - Mr. Hyde
Portland
http://www.datsun2000.com
-----Original Message-----
From: owner-datsun-roadsters@autox.team.net
[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of Mike H.
Sent: Thursday, September 29, 2005 5:17 AM
To: datsun-roadsters@autox.team.net
Subject: 67-1600 Brake Switch
Hi Guys,
Any of you know of a part interchange number or aftermarket replacement for
early
67-1600 single cyl. brake light switch?
Thanks,
Mike H. '67-1600
|