This is the acknowledged "Where the hell did that little plastic splined
shaft thing go"
method!!!
Jim
Chesapeake, Virginia
>From: Andy Cost <andycost@earthlink.net>
>Reply-To: Andy Cost <andycost@earthlink.net>
>To: datsun-roadsters@autox.team.net
>Subject: Re: Clutch Replacement
>Date: Mon, 14 Jun 2004 17:42:15 -0500 (GMT-05:00)
>
>I have not needed the clutch alignment tool. I just finger tighten the
>pressure plate and eyeball the clutch. I then install the tranny on the
>motor. When you ram the tranny on it should align the clutch with the
>shaft. Then you must be careful when taking the tranny back off not to
>allow the clutch to move. Once it is off you can tighten the pressure
>plate all the way and put the tranny back on.
_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar get it now!
http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/
|