There is a bolt with a large head that is screwed into the shaft that must
be removed prior to pulling the clutch bearing off of the shaft. Caution,
the bolt has a left hand thread and must be turned clockwise to remove it.
The clutch assembly should be replaced with an appropriate spacer.
Stan
==========
At 08:19 PM 4/21/2004 -0700, Dana & Joni Holgate wrote:
>Hi! I've run into a snag removing the fan/water pump pulley. I've got the
>fan off, but the little 'X'-shaped piece that it screws into just spins.
Do I
>need some kind of puller? Thanks for the pointer.
|