Hello all,
Check the dashpot springs. Sometimes folks will strech them. They
should be the same length. Try swapping the knobs on top and see if the problem
goes with it. Use some good carb cleaner spray and rags to clean the pistons
and
domes, carbon build up can be a problem. If all else fails swap the pistons
from front to rear. Each dome is precision honed to fit the particular piston
and they may have been swapped. Check the inside if the tight one for shiny
spots. It might have a dent in it. I ended up painting one with blue machinest
dye and using 400 wet or dry to polish out a bump. Let us know what you find.
keith
> Since we're on the subject...
> When I push up on one of my suction pistons, it doesn't go up as
> smoothly and takes more pressure than the other. Is there anything I can
> do to adjust this? I've had them apart and there doesn't seem to be
> anything binding. Any suggestions?
>
> have a great day,
> Ed
> 68' 1600
> http://ed.sawyer.home.comcast.net
|